8433A REV A Norge Dryer Parts List

Idler pulley assembly

The idler pulley wheel provides the tension for a multi-ribbed belt and helps the belt to rotate the drum. The drum will not spin if the idler pulley fails to put the correct amount of tension on the belt. The wheel is white in color and is made of plastic. If the drum will not tumble, is noisy, or will not start, you may need to replace this part. This idler pulley is a genuine OEM part. Please remember to disconnect the power to your dryer before you start your repair.

Dishwasher door gasket with strike - black (dishwasher door seal and strike kit)

This one-piece door gasket provides a water tight seal between the tub and the door, to keep water from leaking out of your dishwasher. If your dishwasher is leaking, tears, or there are gaps in your gasket, you may need to replace the door gasket. This black door gasket is made of rubber, includes a new latch strike plate for the door latch, and is a genuine OEM part.

Bake element

This genuine OEM bake element has push-on terminal ends and provides heat while baking. If the bake element has arcing, is shorted out, the oven is not heating evenly, or little or no heat when baking, you may need to replace it. When replacing the bake element please make sure you disconnect the power to the range. Make sure you do not let the wires fall back through the rear of the oven. This element has been updated by the manufacturer. New installation screws are required and are sold separately.

Retaining ring (snap retaining ring)

The retaining clip goes onto the end of the roller axle and holds the drum roller on to the axle. If the ring is broken or damaged, you will need to replace it. This is a genuine OEM part and is sold individually.

Drum glide (cylinder glide)

The drum glide helps the front drum rotate smoothly and quietly while operating. If your dryer will not tumble or is noisy, the glide could be worn down, causing metal on metal noise. In this case, it will need to be replaced. It is recommended to replace both glides at the same time and two are required for the dryer. The drum glide is a genuine OEM part and is sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Charcoal filter (filter)

The charcoal filter is used to eliminate odors while cooking from that air that circulates through the vent. The filter measures approximately 5-inch by 5-inch and is sold individually. This is a genuine OEM part.

Lower dishrack with wheels (sub 99002396)

The lower dishrack is used to hold the dishes in place during the operation of the cycles. The lower rack measures 5.963” high x 20.46” wide x 22.39” in length. The manufacturer has made some updates to the lower rack, it no longer includes a shelf rack and now has 6 wheels rather than 8. This is a genuine OEM part.

Drip bowl - chrome - 8 inch (pan, drip, (""8""))

The 8” drip bowl, also knows as a drip pan, is located under the burner element to catch anything that may drip or spill over while cooking to make clean up easier. This drip bowl measures 8” in diameter at its widest point at the top, and is chrome in color. This part works with terminal style plug in. This is just the drip bowl; the trim ring is not included must be ordered separately. This is a genuine OEM part and is sold individually.

Door shelf bar (shelf fixed ff)

This shelf is designed to fit a refrigerator. It connects to the refrigerator door, and is used to hold food and beverage items. It is made of white plastic and is approximately 24 inches wide. The door shelf should snap directly into place. This part will be required if your old shelf is cracked, broken or missing.

Drive motor with pulley (motor, assembly 60 hz.)

This drive motor operates the dryer by turning the drive belt which spins the drum and will fit most Whirlpool incorporated dryer brands before 1996. If the motor has shorted out, it will no longer turn the drum and will need to be replaced. The drive motor includes the pulley that is not available separately. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.

Surface element - 8 inch - 220v (use 5303015715)

The coil burner element is eight inches in diameter. It has four turns, 220 volts and looped terminal ends. The coil burner element provides heat to the cooking surface on your range. You might need to replace this part if your element is not heating. It might have shorted out around the coil or the terminal block; you can test the coil to see if the burner or the switch may be at fault. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.

Drip bowl - 6 inch (pan, drip 6"")

Sold individually. This part is located beneath the element and catches any spills.

Leveling foot (foot, dryer (sold individually, 4 recommended))

The adjustable leveling leg is used to support and keep your dryer level. It also allows you to adjust the height of your dryer. You may need to replace the leveling leg if one becomes lost, the thread is stripped off, or it is noisy during operation. The leveling leg is almost 2” long, white in color, and made of plastic. There are four leveling legs used on the dryer, please order quantity needed as they are sold individually. This is a genuine OEM part.

Surface burner terminal block kit (terminal block)

This kit includes the female contact with wires, terminal block and mounting clip.

Refrigerator shelf frame with glass (refrigerator shelf)